Doov's PROJECTS
  • Home
  • About
  • Projects

Hot Water Mixer Secure

10/21/2020

0 Comments

 
The Revel uses radiant heat and the same heat source for hot water. To regulate the temperature there's a mixer valve located under the dinette seat. It's a thoughtful and welcome addition. However, it's a kinda heavy brass valve sitting on 3 PEX "stalks" about 8-10" long. This is free to sort of wave around under the bench since it's not secured. This seems like it will put a lot of stress on the cheap plastic PEX fittings that used. 

​I decided to secure it.
Picture
The large hose clamp goes over the glycol reservoir, the small clamp goes around the valve and the tubing piece goes inbetween. The tubing piece was a short section of square tubing that I cut one wall out of. Took about 3 minutes. 
This really seems to have solved the problem. 
0 Comments



Leave a Reply.

    Categories

    All
    1975 Norton Rebuild
    1977 BMW R100S
    CNC
    Data Driven Sculpture
    Fadal
    Fadal VH 65
    Microcontrollers
    Miscellaneous
    Motorcycles
    Networking
    Norton Commando
    Renishaw Probes
    Sensors
    Shop
    Winnebago Revel

    Archives

    February 2022
    February 2021
    November 2020
    October 2020
    April 2020
    January 2020
    September 2019
    June 2019
    May 2019
    March 2019
    August 2018
    September 2017
    October 2016
    August 2016
    May 2016
    January 2016
    December 2015
    November 2015
    February 2015
    October 2014
    September 2014
    August 2014
    May 2014
    September 2010

Proudly powered by Weebly
  • Home
  • About
  • Projects